[TEL0078] WiFi Shield V3 PCB Antenna (802.11b/g/n)

This WiFi Shield V3 supports AP+STA dual mode, and is extremly easy to connect to router network. You only need a mobile phone or Pad to log in the AP network of this module(similar to the way with a router). After logging in the module, it is ready to connect the WIFI network (No AT command setup required, which is often very complex).

More details


$52.90

4 items in stock

  • Currently 0.00/5

Rating: 0.0/5 (0 votes cast)

This package includes:

  • 1 x WiFi Shield V3 PCB Antenna

 

Introduction:

This WiFi Shield V3 supports AP+STA dual mode, and is extremly easy to connect to router network. You only need a mobile phone or Pad to log in the AP network of this module(similar to the way with a router). After logging in the module, it is ready to connect the WIFI network (No AT command setup required, which is often very complex).


This module uses dynamic power management to achieve low power consumption capability (standby: <80uA; normal mode average: 8mA; peak: 200mA). This is especially useful in prototyping which not only demands low power consumption, but also requires a standby mode. The module provides UART(TTL) to IEEE802.11b/g/n wireless communication. IEEE802.11n is a newest wireless transmission protocol which enjoys features such as higher transmission speed, wider coverage, stronger compatibility, and much more safety. Currently many wireless electronic equipment manufacturers have been applying this standard (IEEE802.11n) to a large number of products. With this WIFI Shield, any device with UART can easily set up a wireless network and achieve remote management and controlling.

 

Specification:

  • Working voltage: 5V
  • Frequency range: 2.4 - 2.497GHz
  • Output power: 16dBm
  • Transmission rate: 54Mbps - 1Mbps
  • Transmission distance: <150M
  • Size: 55mm×53mm×11mm
  • Weight: 40g
  • Support IEEE 802.11b/g/n
  • Support AP,Client,Gateway and UART to WLAN mode and so on
  • Support DHCP,automatic access to IP
  • Support allocating IP to salve device in AP mode
  • Support network protocol:TCP/UDP/ARP/ICMP/HTTP/DNS/DHCP
  • The optional working mode:TCP Server/TCP Client/UDP;Support up to 32 Client in TCP Server mode
  • Support most of WIFI encryption algorithm:WEP/WAP-PSK/WAP2-PSK/WAPI;Type of encryption:WEP64/WEP128/TKIP/AES  
  • Support transparent UART/protocol data transmission mode;Up to 1M cache space;Highest baud rate:460800bps  
  • Support UART(TTL) to wireless applications  
  • Drag down the level of the Reload IO pin for one sencod,you can restore factory settings.So do not worry about the wrong settings.  
  • Support running in AP mode and the node (Station) mode;The real hardware AP, so Android can directly access it.  
  • Provide AT command configuration  
  • Provide the friendly web configuration page,and can be configured by webpage  
  • Serial frame delay and the amount of data can be set.  
  • Support routing/bridge mode network architecture  
  • Designed by standard Arduino stack, and can be easily put on the standard Arduino, MEGA, Romeo board or shield  

 

Download:

 

Cart  

No products

Shipping $0.00
Total $0.00

Cart Check out

PayPal