[DFR0010] DFRduino Nano V3.1 (Arduino Nano Compatible)

The DFRduino Nano USB Microcontroller V3.1 (ATMega 328) is a breadboard ready version of the Arduino mini with integrated USB. This Nano has everything that the Diecimila has (electronically) with more analog input pins and an on-board +5V AREF jumper. 

More details


$18.90

10 items in stock

  • Currently 0.00/5

Rating: 0.0/5 (0 votes cast)

This package includes:

  • 1 x DFRduino Nano V3.1 with SmartDAQ firmware (8 Analog Pins and 18 Digital Pins)

 

Introduction:

The DFRduino Nano USB Microcontroller V3.1 (ATMega 328) is a breadboard ready version of the Arduino mini with integrated USB. This Nano has everything that the Diecimila has (electronically) with more analog input pins and an on-board +5V AREF jumper. The Nano automatically senses and switches to the higher power supply, so there is no need for a power select jumper.

 

The nano's pin layout works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one top, power and ground on the other). The DFRobot DFRduino Nano USB Microcontroller V3.1 (ATMega 328) can be powered via the mini-B USB connection, 6-20V unregulated external power supply (pin 30), or 5V regulated external power supply (pin 27). The power source is automatically selected to the highest voltage source.

Version History

  • v3.0 - improved the analog port pin mapping to be compatible with original Arduino Nano
  • v3.1 - changed the Mini USB port to Micro USB port

 

NOTE: This DFRduino Nano V3.1 is pre-installed with SmartDAQ firmware where user can directly to use it to read data from SmartDAQ Android app. 

 

Specification:

  • Microcontroller: Atmel Atmega328-20AU
  • Operating Voltage (logic level): 5V
  • Input Voltage (recommended): 7-12V
  • Input Voltage (limits): 6-20V
  • Digital I/O Pins: 14 (of which 6 provide PWM output)
  • Analog Input Pins: 8
  • DC Current per I/O Pin: 40 mA
  • Flash Memory: 32 KB (of which 2KB used by bootloader)
  • SRAM: 2 KB
  • EEPROM: 1 KB
  • Clock Speed: 16 MHz

 

Features:

  • Automatic reset during program download
  • Power OK blue LED on the bottom
  • Green (TX), red (RX) and orange (L) LED
  • +5V to AREF jumper
  • Auto sensing/switching power input
  • Small Micro USB for programming and serial monitor (cable not included)
  • ICSP header for direct program downloads
  • Power OK blue LED on the bottom
  • Standard 0.1” spacing DIP (breadboard friendly)
  • Manual reset switch

 

Download:

  • Arduino source code (UNO, MEGA 2560, Leonardo & Nano) for SmartDAQ : Link

 

Cart  

No products

Shipping $0.00
Total $0.00

Cart Check out



PayPal